Choose a nylon watch strap by lug width, the space beneath the spring bars and the way you want it to close. The same 20 mm lug opening can take a thin pass-through strap comfortably and leave too little room for a thicker one. If you want more precise adjustment between buckle holes, compare fabric straps with a hook-and-loop closure as well.
Compare nylon and fabric watch straps
| Configuration | Material and length | Why choose it |
|---|---|---|
| Watchdives SD2301 · black, 22 mm | Nylon, 275 mm excluding buckle, 1.5 mm thick. | Choose it if you want a more substantial weave and have room to pass the strap through. |
| Militado smooth nylon · green, 18 mm | Nylon, 260 mm excluding buckle, stainless steel buckle. | A narrower option for a watch with 18 mm lugs. Compare its length with a strap you already wear. |
| Watchdives 007 woven fabric · black, 20 mm | Listed as high-density woven canvas, 270 mm excluding the steel buckle. | A pin-buckle pass-through for a 20 mm opening with room to thread the strap and tuck the tail. |
| Watchdives hook-and-loop · black, 20 mm, M | The detailed specification lists soft polyester and a titanium buckle. M is 260 mm excluding the buckle. | Adjust the overlap instead of choosing a buckle hole. The listing suggests M for wrists of 16–18 cm. |
The figures are strap lengths from the product listings. The watch case, bar position and amount of fabric that folds back all affect the usable wrist range. Canvas describes the weave. If the fibre matters to you, check the material line for the exact strap.
Check the gap before threading a pass-through strap
Measure between the inside faces of the lugs. Then check the gap between each bar and the case. Look at the thickest part you need to feed through, including the finished tip. With fixed bars, the strap must pass through both gaps without removing the bars. The SD2301's listed 1.5 mm thickness is a useful starting point, but the stitched edge or tip can still be the tightest part of the fit.

With otherwise similar fabric, a route that puts one layer beneath the case adds less height than one that puts two layers there. If the watch already sits high, check the strap construction and the route shown in our NATO-style installation guide before deciding.
Choose the closure and length together
A pin buckle has set holes and leaves a tail to tuck into the keepers. Check that you can reach a comfortable hole with enough tail to stay in its keeper. A hook-and-loop strap lets you set the overlap where it feels comfortable. Make sure enough of the two surfaces mate firmly without the closure ending on the underside of a lug. The 20 mm Watchdives hook-and-loop strap also has an L size, listed at 290 mm excluding the buckle for wrists of 18–22 cm. If you are near the size boundary, compare the length with your usual strap and allow for the watch head.

For a replacement, start with the watch strap sizing guide and confirm the exact colour, width and length before ordering. Use the watch straps collection if you also want to compare rubber, leather or a bracelet.
