Skip to content
WATCHDIVESWATCHDIVES
How to Put On a NATO Strap: Single Pass, Double Pass and Fixed Bars

How to Put On a NATO Strap: Single Pass, Double Pass and Fixed Bars

A pass-through watch strap threads under the case and through both strap bars. For a NATO-style strap with a short retaining section, feed the long end through that section's keeper after threading it through the watch. Check the strap width and the clearance beneath each bar before fitting it.

Single-pass vs double-pass NATO-style straps

Design Under the case What to check
Single-pass One long strap, one fabric layer. Hold the watch while unbuckling and check bar clearance.
Double-pass with retaining section Main strap plus the short section beneath the watch. Check that the keeper lines up and both layers lie flat.

Compare the path the material takes under the case. With the same fabric thickness, a single layer raises the case less than two layers. A short retaining section helps position the watch between the keepers. On a single-pass design, hold onto the watch when unbuckling so it cannot slide off the loose end.

How to put on a pass-through strap

  1. Check the width and clearance. Read the lug width for the exact watch or measure the inner gap. Check that the strap tip can pass between each bar and the case without force.
  2. Set the buckle at the top. Lay the watch face up on a soft surface, with 12 o'clock pointing away from you. Put the buckle end above the watch so the free end can feed in from that side.
  3. Thread both bars. Feed the tip through the 12 o'clock gap towards the case back. Run it underneath the case, then bring it out through the 6 o'clock gap.
  4. Finish the route for your strap. On the version with a short retaining section, feed the free end through that section's keeper. Check that both layers lie flat. On a single-pass strap, slide the watch to the position you want on the long strap.
  5. Buckle and tuck the tail. Fasten it over a soft surface, guide the remaining length through the keepers and fold the tail back if it is long enough. Check that the watch and buckle sit where you want them and the strap can flex at the bars.

Fixed bars require a strap that can pass around them

The Tactical Frog FX-Diving V4 is a 22mm fixed-bar example. Its supplied fabric band uses a self-gripping closure. A replacement must be able to wrap around or pass under the fixed bars. A conventional two-piece strap with closed spring-bar sleeves cannot be installed on fixed bars in the usual way. Check the bar-to-case gap at both ends before ordering: the strap or its finished tip can be too thick even when the width matches.

Black-date Tactical Frog FX-Diving V4 with fabric strap
Tactical Frog FX-Diving V4, Black Date. Listed 22mm fixed bars and supplied fabric band.

Choose 20mm or 22mm before choosing the color

The 007 woven fabric strap comes in 20mm and 22mm widths, with 27cm of listed length excluding its steel buckle. Use that length to compare against a strap you already wear, including how much tail you normally tuck. The width selects the bar opening. For a fixed-bar watch, the clearance check still determines whether this strap can pass through.

Army-green 007 woven watch strap with steel buckle
007 woven fabric strap, Army Green, 22mm.

Still choosing the band? Our nylon and fabric strap comparison explains what changes between fabrics, closures and widths.

For other attachments and measuring steps, use the watch strap sizing guide or browse dive watch straps. See the Tactical Frog FX-Diving comparison for the fixed-bar automatic model and its separate solar chronograph counterpart. Cabot Watch Company's fitting guide illustrates its own retaining-strap design.

Leave a comment

Your email address will not be published..

Cart 0

Your cart is currently empty.

Start Shopping