Skip to content
WATCHDIVESWATCHDIVES
Watchdives WD007: Double-Domed vs. Top Hat Sapphire

Watchdives WD007: Double-Domed vs. Top Hat Sapphire

The Watchdives WD007 V4 has double-domed sapphire and a listed overall height of 12.2 mm. The WD007 Top Hat has a raised crystal edge and measures 12.5 mm including the crystal. On the two black calendar versions below, the listed case diameter, lug span, automatic calibre and choice of nylon stay the same. That makes them a practical comparison if you are choosing for the way the sapphire rises above the bezel.

Compare WD007 double-domed and Top Hat sapphire

Configuration Crystal profile and total height Shared listed dimensions
WD007 V4 Β· C3 Black Calendar / SL3001 / Nylon Double-domed sapphire, 12.2 mm including crystal 42 mm titanium case, 48.95 mm lug-to-lug, 20 mm lug width
WD007 Top Hat Β· C3 Black Calendar / SL3001 / Nylon Raised Top Hat sapphire, 12.5 mm including crystal 42 mm titanium case, 48.95 mm lug-to-lug, 20 mm lug width

Both selections use the Peacock SL3001, have a date at six o’clock and are listed with clear anti-reflective coating. The 0.3 mm difference compares the published thickness of the complete watches. It does not tell you the thickness of either sapphire part on its own.

Look at the edge from the side

Double-domed sapphire has a curve on both the outside and the inside. On the V4, the rounded upper surface slopes towards the bezel. The Top Hat listing gives the raised edge its own silhouette. Look nearly level with the bezel to see that edge and the transition into the upper surface. Choose the V4 for a rounded profile or the Top Hat if you like a more visible crystal edge.

WD007 V4 from the side showing the curved sapphire profile
WD007 V4 double-domed sapphire
WD007 Top Hat from the side showing the raised sapphire edge
WD007 Top Hat sapphire

The gallery photos show the profiles at different angles and under different lighting. Judge the shape and position of the crystal edge from them. Reflections and distortion depend on the angle, the profile and the coating. The photographs cannot establish which watch reflects less in the same conditions.

How flat sapphire fits into the comparison

The Watchdives WD0022 Elementum in Black MOP uses flat sapphire and a fixed steel bezel. It gives you a straight surface above the dial. Its listed 10.9 mm thickness belongs to a different case and movement, so the numbers do not isolate what a crystal swap would do to the WD007. For a lower overall watch, compare the caseback-to-crystal measurement of each complete watch.

Blue dial WD0022 Elementum from the side showing its flat sapphire surface
WD0022 Elementum flat sapphire, photographed on the blue dial

When ordering, start with the profile and check the date, dial and band together. The Top Hat and double-domed watches have separate listings. For more on the material or coating, see our sapphire crystal guide. For a sleeve or cuff comparison, use our watch thickness measuring guide.

Leave a comment

Your email address will not be published..

Cart 0

Your cart is currently empty.

Start Shopping