Skip to content
WATCHDIVESWATCHDIVES
How to Use a Tachymeter on a Watch

How to Use a Tachymeter on a Watch

A tachymeter turns a short, timed interval into an average rate per hour. Start the chronograph at the beginning of a known distance or a countable task. Stop it at the end and read the printed scale where the chronograph seconds hand points. For example, one kilometre in 36 seconds works out to 100 km/h.

Find the tachymeter scale and the right hand

Look for a rate scale around the edge of the dial or bezel, often marked β€œTachymeter”. Its higher numbers sit near the start of the timed interval. The ordinary minute track counts seconds or minutes, while the tachymeter scale converts that time to a rate. On the Watchdives VK63 examples below, use the long central chronograph seconds hand. The small running-seconds display keeps time independently.

Vintage Black Watchdives WD1863A with a numbered tachymeter bezel
Watchdives WD1863A, Vintage Black. The long central chronograph hand reads the outer scale.

Read it in three steps

  1. Choose the distance or unit. For speed, use a measured distance. For work rate, decide what counts as one complete item or cycle.
  2. Start, then stop the chronograph. Begin from zero. If the pushers have locks, follow the watch maker’s instructions for releasing them. On the two VK63 examples here, the upper pusher starts and stops the timer. Take the reading before resetting with the lower pusher.
  3. Read the rate at the stopped hand. Over one kilometre, the value is km/h. Over one mile, the same value is mph. The distance you measured sets the unit.
What you timed Elapsed time Single-unit scale reading Measured rate
1 kilometre 36 seconds 100 100 km/h
Β½ kilometre 36 seconds 100 50 km/h
2 completed items 45 seconds 80 160 items per hour

Use the same scale for shorter distances or more than one item

The formula is units measured Γ— 3,600 Γ· seconds elapsed. If you time half a kilometre in 36 seconds, halve the single-unit scale reading of 100 to get 50 km/h. If you count two completed items in 45 seconds, double the single-unit reading of 80 to get 160 items per hour. These are average rates over the interval you measured.

Check the scale's limits before comparing chronographs

Read the markings present on your own watch. On a conventional single-turn scale, the useful interval must land inside the marked range on that first trip around the dial. If the interval exceeds one revolution, use the full elapsed time and calculate the rate. A hand at the 15-second position after 75 seconds cannot be read as a 15-second interval.

The Watchdives WD6263 uses contrasting rate numerals around the outside of the dial. When comparing models, check that you can see the central hand and read the outer scale at the angle you normally wear your watch. A chronograph with a plain bezel or a 60-minute track can still time events. Look for a printed rate scale if you want a direct tachymeter reading.

Blue Watchdives WD6263 chronograph with its numbered outer bezel
Watchdives WD6263, Blue with 5-hole clasp.

See our chronograph guide for subdial layouts, the VK63 movement guide for its controls, or browse the chronograph collection. Seiko's tachymeter examples and the Time Module VK63 operation manual cover scale reading and pusher operation respectively.

Leave a comment

Your email address will not be published..

Cart 0

Your cart is currently empty.

Start Shopping